OT Defense: Deluxe Firearm Stippling Kit

100% Made in the USA!  From the molded case to the tips to the wire brush, this kit is completely made in the USA and all tips are specifically designed for firearms, not wood.  

Contains:

• 25 Watt Woodburner with a short shaft for ease of control and a moderate temperature. 
• Tan Hard Case for convenient storage of all your stippling items. 
• One 20LPI Waffle Tip (shown)
• One 20LPI Square Tip
• One 20LPI Finish Tip
• One Point Tip
• One 16LPI Waffle Tip
• One 12LPI Waffle Tip
• One Diamond Tip (shown)
• One X Tip (shown)
• One Wagon Wheel Tip (shown)
• One Chisel Tip
• One Small Round Tip
• One Large Round Tip
• One Rectangle Tip (shown)
• Two Large plastic vial to hold the tips  
• Three small plastic vials for the 20LPI tips and Finish Tip
• One piece of practice material, 2x6' and 1/8" thick so you can stipple both sides
• One wire brush for keeping your tips clean  

This kit does not include all OTD tips since the lineup changes often.

Legal Disclaimer:  This Stippling Kit must be used by a qualified gunsmith. If used incorrectly, injury, death, or property damage could occur. If not used correctly by a qualified gunsmith, Oregon Trail Defense LLC makes NO WARRANTY, EXPRESS OR IMPLIED regarding this kit. If not used by a qualified gunsmith the user releases and agrees to indemnify Oregon Trial Defense LLC from any claim of damages resulting from a malfunction, warranty violation, or property damage, and waives any claim for liability against Oregon Trail Defense LLC.

Common Sense:  Take your time, practice on some old A2 grips, magazine floor plates, old clinton era 10 round Glock 17 mags (unless you live in a state that requires you keep them), practice material, etc.  This will give you familiarity with the tool/tips, and enable you to recognize some important things (outlined below).  Then and only then should you move on to your firearm.  If in doubt, take it to an experienced gunsmith.